Tune in with Hakko
Removing QFP or SOP
Both the SMD Quad and Tunnel type soldering tips are capable of heating multiple pins or lead wires at once and is used for rework of SMDs. SMD Quad Tip is...
Removing QFP or SOP
Both the SMD Quad and Tunnel type soldering tips are capable of heating multiple pins or lead wires at once and is used for rework of SMDs. SMD Quad Tip is...
Soldering Quad Flat Packages (QFP)
Both drag soldering and point soldering are suitable for soldering Quad Flat Packages (QFP). Read on to learn more!
Soldering Quad Flat Packages (QFP)
Both drag soldering and point soldering are suitable for soldering Quad Flat Packages (QFP). Read on to learn more!
Soldering Connectors
The spatula type is capable of heating multiple pins or lead wires at once and is used for rework of SMDs, mainly for thermo-compression of Printed Wiring Boards (P.W.B.) and...
Soldering Connectors
The spatula type is capable of heating multiple pins or lead wires at once and is used for rework of SMDs, mainly for thermo-compression of Printed Wiring Boards (P.W.B.) and...
Cleaning After BGA Removal
To clean up your board after removing multiple pins or lead wires, Hakko recommends using the Spatula Shaped (SMD) Soldering Tip.
Cleaning After BGA Removal
To clean up your board after removing multiple pins or lead wires, Hakko recommends using the Spatula Shaped (SMD) Soldering Tip.
Soldering Chip Parts
While shapes BC/C, B and D can be used for soldering chip parts, the BC/C shapes are recommended to form the ideal fillet and the best soldering joint. Read on...
Soldering Chip Parts
While shapes BC/C, B and D can be used for soldering chip parts, the BC/C shapes are recommended to form the ideal fillet and the best soldering joint. Read on...
Soldering Tiny Chip Parts (0603)
The recommended tip size for micro-soldering is one that matches the width of the micro-component (A), or A-0.1mm. Tips that are slightly larger than "A" can be used if it...
Soldering Tiny Chip Parts (0603)
The recommended tip size for micro-soldering is one that matches the width of the micro-component (A), or A-0.1mm. Tips that are slightly larger than "A" can be used if it...